B1035 Nissan Titan Drivers Seat And
B1035 Nissan Titan Driver And Front
B1035 Nissan Titan Driver Air Bag

When a Nissan gets into a car accident (crash or collision) theres the possibility of the airbags going off triggered by the impact crash sensors.

Very similar to an airbag, this charge is set off in the event of an accident and tightens the seat belts.

Whether a Nissan has been in a fender bender or a bad accident, this is a much needed service.

Also, if you are a rebuilder or buy cars from salvage yards these savings can really add up and offer a peace of mind.

All Nissan airbag codes can be reset with our programming service.

It operates simultaneously with the SRS air bag system in the event of a frontal collisionwithanimpactexceedingaspecifiedlevel.

This system includes seat belt switch inputs and dual stage front air bag modules.

The SRS system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front air bag, depending on the severity of a collision and whether the front occupants are belted or unbelted.

Information necessary to service the system safely is included in the SRS and SB section of this Service Manual.

WARNING: To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in the event of a collision which would result in air bag inflation, all maintenance must be performed by an authorized NISSANINFINITI dealer.

Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system.

For removal of Spiral Cable and Air Bag Module, see the SRS section.

Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this Service Manual.

SRS wiring harnesses can be identified by yellow andor orange harnesses or harness connectors.

Precautions for SRS AIR BAG and SEAT BELT PRE-TENSIONER Service EHS0013T Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.

Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes.

For approximately 3 minutes after the cables are removed, it is still possible for the air bags and seat belt pre-tensioners to deploy.

Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.

The air bag diagnosis sensor unit must always be installed with the arrow mark pointing toward the front of the vehicle for proper operation.

Also check air bag diagnosis sensor unit for cracks, deformities or rust before installation and replace as required.

The spiral cable must be aligned with the neutral position since its rotations are limited.

Do not attempt to turn steering wheel or column after removal of steering gear.

B1035 Nissan Titan Driver And Front

Always place driver and front passenger air bag modules with the pad side facing upward and seat mounted front side air bag module standing with the stud bolt side facing down.

Conduct self-diagnosis to check entire SRS for proper function after replacing any components.

After air bag inflates, the front instrument panel assembly should be replaced if damaged.

Occupant Classification System Precaution Replace occupant classification system control unit and passenger front seat cushion as an assembly.

Trouble Diagnosis Precaution Whenyoureadwiringdiagrams,refertothefollowing: GI-14, HowtoReadWiringDiagrams in GI section PG-4, POWER SUPPLY ROUTING CIRCUIT in PG section When you perform trouble diagnosis, refer to the following: GI-11, HOW TO FOLLOW TEST GROUPS IN TROUBLE DIAGNOSES in GI section GI-27, How to Perform Efficient Diagnosis for an Electrical Incident in GI section Check for any service bulletins before servicing the vehicle.

EHS0013U EHS0013V A B C D E F G SRS I J K L M SRS-3 4 PREPARATION PREPARATION Special Service Tools The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here.

The collision modes for which supplemental restraint systems are activated are different among the SRS systems.

For example, the driver air bag module, front passenger air bag module and front seat belt pre-tensioners are activated in a frontal collision but not in a side collision.

B1035 Nissan Titan Driver Air Bag

B1035 Nissan Titan Drivers Seat And

SRS configurations for some collision modes are as follows: SRS configuration Frontal collision Left side collision Right side collision Rollover Driver air bag module Front passenger air bag module Front LH seat belt pre-tensioner Front RH seat belt pre-tensioner Front LH side air bag module (if equipped) Front RH side air bag module (if equipped) LH side curtain air bag module (if equipped) RH side curtain air bag module (if equipped) SRS-6 7 SUPPLEMENTAL RESTRAINT SYSTEM (SRS) Front Seat Belt Pre-tensioner with Load Limiter The seat belt pre-tensioner system with load limiter is installed for both the drivers seat and the front passengers seat.